Is this 3D model free to download?

Yes, Craftsman V20 Blower inflation adapter is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by Tsaman01, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Craftsman V20 Blower inflation adapter

Source: Thingiverse by Tsaman01

The Craftsman V20 Blower inflation adapter is a free printable 3D model from Thingiverse by Tsaman01. This adapter allows you to use your Craftsman v20 blower to inflate pool toys more easily! For the longest time I'd been holding the blower against the deflation valve on these. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

30 saves Source: Thingiverse Updated 2026-10-06 License: CC-BY-SA · commercial OK Category: Outdoor & Garden

Tags: Blower, craftsman v20, inflator, inflator nozzle

About this model

This adapter allows you to use your Craftsman v20 blower to inflate pool toys more easily! For the longest time I'd been holding the blower against the deflation valve on these giant pool toys and always wanted to put one of these together to make it easier - so, here is what I came up with! This is 79mm wide to fit into the end of the blower, and steps out to 81mm for a stop, and then necks down to 25 and 15mm for the inflator side. If I were going to re-do it I'd probably reduce the curve on the dome - I got some stringing inside when I printed it without supports, but it wasn't too horrible. This just relies on a friction fit - you'll still be holding it on the end of the blower, but its a LOT easier than holding the neck of the toy and trying to create an air seal with your hand around…

Frequently asked questions

Is this 3D model free to download?: Yes. Craftsman V20 Blower inflation adapter is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Tsaman01.
Who made this model?: Designed by Tsaman01, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.