CR-10 Control Box Stabilizer (Remix)
Source: Thingiverse by Matt2468rv
The CR-10 Control Box Stabilizer (Remix) is a free printable 3D model from Thingiverse by Matt2468rv. I took the original CR-10 control box stabilizer design and added some sleek fillets (only because I don't like the look of sharp edges) and also made it a little less thick. You can download the STL file from the original listing below and print it at home.
About this model
I took the original CR-10 control box stabilizer design and added some sleek fillets (only because I don't like the look of sharp edges) and also made it a little less thick since it doesn't need to be quite so bulky to do its job. This will allow you to mount the filament spool off to the left side of the control box without it tipping over. One of these placed toward the back of the control box should work fine, but for good measure I recommend printing two of these - one for the front and one for the back.
Frequently asked questions
- Is this 3D model free to download?
- Yes. CR-10 Control Box Stabilizer (Remix) is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Matt2468rv.
- Who made this model?
- Designed by Matt2468rv, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in CR-10
