CR-10 Dual LED Strip Mount (Snap-in)
Source: Thingiverse by Matt2468rv
The CR-10 Dual LED Strip Mount (Snap-in) is a free printable 3D model from Thingiverse by Matt2468rv. I didn't like any of the LED mounts/holders I saw, so I designed my own. You can download the STL file from the original listing below and print it at home.
About this model
I didn't like any of the LED mounts/holders I saw, so I designed my own. This mount holds two strips of LEDs beneath the top bar and snaps in without any extra parts required. Just glue in your LED strips. I used two 5630 LED strips and this thing is BRIGHT! Here's a link: The mount has a gap on either side toward the back for wire routing. As a finishing touch, you can add aluminum foil on the inside to reflect more light (as shown in the picture). I cut two strips of foil and used double sided tape to stick it down. Not required, but it does help. I also zip-tied a switch on top of my CR-10 so I can turn the LEDs on and off, and I routed the wires down the back using pieces of the plastic/rubber strips that come with the CR-10.
Frequently asked questions
- Is this 3D model free to download?
- Yes. CR-10 Dual LED Strip Mount (Snap-in) is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Matt2468rv.
- Who made this model?
- Designed by Matt2468rv, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in CR-10
