Dehydrator Tray Extension for Westinghouse WFD100W
Source: Thingiverse by davidhbrown
The Dehydrator Tray Extension for Westinghouse WFD100W is a free printable 3D model from Thingiverse by davidhbrown. Many comments on a dominant e-tailer's site suggested this was a good food dehydrator to use for drying filament, but most also pointed out that you had to cut apart the racks. You can download the STL file from the original listing below and print it at home.
About this model
Many comments on a dominant e-tailer's site suggested this was a good food dehydrator to use for drying filament, but most also pointed out that you had to cut apart the racks, preventing its intended use for drying food, and Westinghouse doesn't seem to sell spare racks. These extensions fit between existing racks to separate the racks enough to fit a filament spool in-between. NOTE that this is ONLY for the model WFD100W ... there is a slightly more expensive "101" model which looks to have different trays. The 73mm high extension -- along with the height of the rack you put it on -- allows the widest spool I have (just over 80mm) to fit with a filament clip still attached to the side. If you print just one set, this would probably be the most useful. This one is white in the photos. I p…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Dehydrator Tray Extension for Westinghouse WFD100W is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by davidhbrown.
- Who made this model?
- Designed by davidhbrown, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
