Japanese Lantern w snap fixures
Source: Thingiverse by megasega
The Japanese Lantern w snap fixures is a free printable 3D model from Thingiverse by megasega. This is a remake of a classic Japanese lantern. You can download the STL file from the original listing below and print it at home.
About this model
This is a remake of a classic Japanese lantern. Printed in just three different parts: - a base fixed to the wall or ceiling where an LED lamp gets fitted - four equal side parts, which snap together - a top part which has no snaps yet, but fits in perfectly in order to be glued. The base and side parts can be fixed with short 1.75 filament pieces at each corner. I melted the ends of each half inch filament piece and pressed them flat in order to make them look like a small nail. Then some square transparent paper sheets get cut and glued inside top and side pieces. Pro tip: transparent Nail varnish works like a charm. Just a small drop at each corner and each corner of the inside rectangle. Remember to use it with cool LED lights only, because the old glow-wire bulbs produce too much heat…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Japanese Lantern w snap fixures is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by megasega.
- Who made this model?
- Designed by megasega, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Japanese
