Robot cat
Source: Thingiverse by ittonru
The Robot cat is a free printable 3D model from Thingiverse by ittonru. My project is a robot cat. You can download the STL file from the original listing below and print it at home.
About this model
My project is a robot cat. The project is in development, I will publish some details as soon as they are ready. To build the need servo drives MG90S. Assembly instructions do not have time, but I think it is not too difficult to repeat the model, since all the details are unified. The STM32 board used as the controller can probably be used by Arduino Mega, but now I don’t have one, the UNO and NANO do not have enough outputs that can control the servo. At STM32F103C8 there were 14 of them, but it was enough end-to-end, I had to sacrifice my tail, which upsets the model a bit and creates an increased load on the servo in the vertebral part (now I understand why cats need tails). I publish an example sketch for Arduino IDE allowing the robot to stand up.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Robot cat is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by ittonru.
- Who made this model?
- Designed by ittonru, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Robot
