Lightweight Spool-holder v22 for Voxelab Aquila & Ender 3
Source: Thingiverse by fukumay
The Lightweight Spool-holder v22 for Voxelab Aquila & Ender 3 is a free printable 3D model from Thingiverse by fukumay. We designed spool holder for Voxelab Aquila which is low position and slippery, so I will share it. You can download the STL file from the original listing below and print it at home.
About this model
We designed spool holder for Voxelab Aquila which is low position and slippery, so I will share it. We use 2mmφ iron rod for the shaft, and it can rotates as well as bearing one that I tried to make as a prototype. I basically made it with ABS because it's wanted strength, but it seemed that it was better to make the shaft part with PLA. Since it's attached to 2020 aluminum frame, it's expected to be available on most of Ender 3 models. Remove the cap on the side of the 2020 frame and slide it on. For reference, round bars are sold at DIY store for around 50¢ per meter. Voxelab Aquilaのスプールホルダーの配置低くして滑りを良くするための設計を行いましたので共有致します。2mmφの鉄棒をシャフトに用いており、併せて試作してみたベアリング版と遜色なく回転する様子でした。強度が欲しいため基本的にABSで製作したのですけど、シャフト部分はPLAで作った方が滑りが良い様子でした。 2020アルミフレームを用いているため多くのEnder3系機種で利用可能な見込みです。本体側面のキャップを外し、スライドして装…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Lightweight Spool-holder v22 for Voxelab Aquila & Ender 3 is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by fukumay.
- Who made this model?
- Designed by fukumay, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Lightweight
