Exo-Suit (Part 3: Gauntlets)
Source: Thingiverse by Roman13
The Exo-Suit (Part 3: Gauntlets) is a free printable 3D model from Thingiverse by Roman13. These gauntlets are an addition to my Exo-suit project that replace the original stirrup style hands. You can download the STL file from the original listing below and print it at home.
About this model
These gauntlets are an addition to my Exo-suit project that replace the original stirrup style hands. I've included a separate Cuff so they can be worn alone without rest of the suit. Everything except the knuckle hardware can be printed at 20% infill with 0.6mm sides. The Knuckle hardware needs to be printed at 100% infill. Print at 20mm/sec or slower, max 0.2mm layer height and supports "everywhere". I've included only one copy of each file. The fingers are the same from left to right hand. The thumb is the same but assembled opposite. The end pieces of the fingers can break if bent too far when assembled. Make sure the parts are clean of all supports, holes are cleaned out and the posts are round. Test fit and verify all parts before melting or gluing the retainers down. Please follow t…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Exo-Suit (Part 3: Gauntlets) is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Roman13.
- Who made this model?
- Designed by Roman13, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
