Macro Focus Rail to Automate Shooting Stacked Photos
Source: Thingiverse by MontanaMonk
The Macro Focus Rail to Automate Shooting Stacked Photos is a free printable 3D model from Thingiverse by MontanaMonk. The printed parts for this project are the housing and mounting parts. You can download the STL file from the original listing below and print it at home.
About this model
The printed parts for this project are the housing and mounting parts. The entire project consists of other parts which are listed in the description of the YouTube video at: For complete information, please watch the video. I am listing the parts and how it works again here in case they don't appear with the video link. Parts Steel rails ~ 9" long x 8mm (2) Arduino Uno board EasyDriver Rail supports (4) Linear Bearings (4) Stepper Motor GT2 20 tooth pulley (2) GT2 timing belt ~30" On-Off-On switch Limit switch (2) LED (3) Red Green Orange Resistor 220 ohm (3) 1/8" mono jack Flash shoe adapter for your camera M2.4x4mm nylon screws M1.7x8mm screws (4) M4x8mm machine screws (12) M3x30 machine screws (4) M5x40 machine screw for idler pulley M5 nut Connection wire and solder Wire tie Wood or m…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Macro Focus Rail to Automate Shooting Stacked Photos is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by MontanaMonk.
- Who made this model?
- Designed by MontanaMonk, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Macro
