LED Light Bar Front & Back CR-10 / CR-10S (No Screws Needed)
Source: Thingiverse by Dooder_Snickel
The LED Light Bar Front & Back CR-10 / CR-10S (No Screws Needed) is a free printable 3D model from Thingiverse by Dooder_Snickel. I was searching for a simple no screws required light bar design for my CR-10S. You can download the STL file from the original listing below and print it at home.
About this model
I was searching for a simple no screws required light bar design for my CR-10S. I couldn't find one to my liking so I made one. Fits nice and snug on the top part of the frame. It has a little tunnel at one end for wires to fit through for connecting the two sides of LED's. At the other end, it has two little holes for putting wires through to make it look neater. Directions: Option 1: All I did was run the wires down the back of one of the aluminum channels near the left z-Axis rod. Then I hooked it up to a 12v wall adapter and put a switch on it. Option 2: You could get power to the lights without using a 12v wall adapter is to tap into the extruders cooling fan I did this with my lights that move with my extruder (There will be a link to that model down below). All you have to do is cut…
Frequently asked questions
- Is this 3D model free to download?
- Yes. LED Light Bar Front & Back CR-10 / CR-10S (No Screws Needed) is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Dooder_Snickel.
- Who made this model?
- Designed by Dooder_Snickel, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in LED
