Is this 3D model free to download?

Yes, Droidlink DS650 Controller Mount is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by JakeRStock, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Droidlink DS650 Controller Mount 3D printable model by JakeRStock

Droidlink DS650 Controller Mount photo 1

Droidlink DS650 Controller Mount photo 2

Droidlink DS650 Controller Mount photo 3

Droidlink DS650 Controller Mount photo 4

Droidlink DS650 Controller Mount

Source: Thingiverse by JakeRStock

The Droidlink DS650 Controller Mount is a free printable 3D model from Thingiverse by JakeRStock. I made a controller mount for the Droidlink system for an R2D2 astromech droid. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

30 saves Source: Thingiverse Updated 2026-10-23 License: CC-BY-SA · commercial OK Category: 3D Printer

Tags: astromech, Baddeley, droid, droidlink, HotRc, mr baddeley, R2D2

About this model

I made a controller mount for the Droidlink system for an R2D2 astromech droid. It uses 2 HotRC DS650 controllers and the Waveshare ESP32-S3 2.06 inch Watch. The stock watch case slides in the mount and hold in well with friction. You can purchase the watch with an internal battery or without. For my purposes I was only able to get the model without the battery and decided to power it with a Magsafe power bank. The back features a slot for a Magsafe ring that is 55mm OD x 45mm ID. I removed the adhesive off the back of the ring and used two part epoxy to glue in place to ensure it will hold. I used the power bank listed below but I believe any Magsafe powerbank 4 inches or under should fit well. I used some of the pre-cut Velcro squares on the back of each DS650 controller to hold in place…

Frequently asked questions

Is this 3D model free to download?: Yes. Droidlink DS650 Controller Mount is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by JakeRStock.
Who made this model?: Designed by JakeRStock, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.