Is this 3D model free to download?

Yes, Mech Hand V11 – Motor-in-Finger is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by yuki135629, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Mech Hand V11 – Motor-in-Finger 3D printable model by yuki135629

Mech Hand V11 – Motor-in-Finger

Source: Thingiverse by yuki135629

The Mech Hand V11 – Motor-in-Finger is a free printable 3D model from Thingiverse by yuki135629. Mech Hand V11 Mech Hand V11 was developed to improve the problems found in the previous generation, Mech Hand V8. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

30 saves Source: Thingiverse Updated 2026-10-28 License: CC-BY · commercial OK Category: Vehicles & RC

Tags: humanoid, humanoid arm, humanoid robot, humanoide, robotic hand, robotic hand kit, robotics, RoboticsProject

About this model

Mech Hand V11 Mech Hand V11 was developed to improve the problems found in the previous generation, Mech Hand V8. In V8, the motors were installed inside the fingers, and a screw mechanism was used to convert the rotational motion of the motor into linear motion. This design provided high driving force, made good use of the long and narrow space inside each finger, and made it possible to fit the motor inside a finger with dimensions close to those of a human hand. However, V8 had one major problem. The finger movement was extremely slow. Because of the large reduction caused by the screw mechanism, it took around one minute for a finger to fully open or close. Although the mechanism was compact and powerful, the operating speed was far too slow for practical use. For V11, I removed the sc…

Frequently asked questions

Is this 3D model free to download?: Yes. Mech Hand V11 – Motor-in-Finger is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by yuki135629.
Who made this model?: Designed by yuki135629, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.